ltc3416efe资料 | |
ltc3416efe |
|
file size : 116 kb
manufacturer:linear description:for proper operation of the md1811, low inductance bypass capacitors should be used on the various supply pins. the gnd pin should be connected to the logic ground. the ina, inb inc, ind, and oe pins should be connected to a logic source with a swing of gnd to vll, where vll is 1.2 to 5.0 volts. good trace practices should be followed corresponding to the desired operating speed. the internal circuitry of the md1811 is capable of operating up to 100mhz, with the primary speed limitation being the loading effects of the load capacitance. because of this speed and the high transient currents that result with capacitive loads, the bypass capacitors should be as close to the chip pins as possible. unless the load specifically requires bipolar drive, the vss, and vl pins should have low inductance feed-through connections directly to a ground plane. if these voltages are not zero, then they need bypass capacitors in a manner similar to the positive power supplies. the power connection vdd should have a ceramic bypass capacitor to the ground plane with short leads and decoupling components to prevent resonance in the power leads. |
1pcs | 100pcs | 1k | 10k | ||
型 号:ltc3416efe 厂 家:linear 封 装:0510 批 号:smd 数 量:4256 说 明: |
|||||
运 费: 所在地: 新旧程度: |
|||||
联系人:林浩/林妮 |
电 话:0755-82532799/82532766/83989559 |
手 机:13510168121/13725556003 |
qq:496982847/351622092 |
msn:linearic@hotmail.com |
传 真:0755-82532766 |
email:maxim_zi@126.com |
公司地址: 深圳市福田区佳和大厦b座1802室 门市部:华强广场 q2a114展销柜 |